Zoom MRS-802 TR1, TR1, TR1, TR1, TR1, EQ HI F, EQ LO G, EQ LO F, CHO SEND, REV SEND, Range:, Range:, Range:, Range:, Default:, Default:, Default:, Default:, ZOOM MRS-802

Reference [Mixer]

Adjusts the amount of high-range boost/cut.

Range: -12 - 0 - 12 (dB)

Default: 0• EQ HI F parameter

TR1

EQ HI F 8000

Adjusts the turnover frequency for high-range boost/cut.

Range: 500 - 18000 (Hz)

Default: 8000

• EQ LO G parameter

TR1
EQ LO G	0

Adjusts the amount of low-range boost/cut.

Range: -12 - 0 - 12 (dB)

Default: 0

• EQ LO F parameter

TR1

EQ LO F 125

Adjusts the turnover frequency for low-range boost/cut.

Range: 40 - 1600 (Hz)

Default: 125

HINT

•If you press the [ENTER] key while the EQ HIGH parameter is displayed, EQ HIGH is turned off. Pressing the key once more turns EQ HIGH on again. In the same way, you can switch EQ LOW between on and off with the [ENTER] key while the EQ LOW parameter is displayed.

•Immediately after switching the display, the audio track or the drum track that was selected before will still be selected. If necessary, switch to another track.

5. Set the EQ parameter for other audio tracks or the drum track in the same way.

6. When you have finished adjusting settings, press the [EXIT] key.

The unit returns to the main screen.

Adjusting depth of send/return effect

This section explains how to adjust the effect depth by setting the volume that is sent from each channel to the send/ return effects (chorus/delay, reverb). Raising the send level will produce a deeper effect.

1. Press the [CHORUS/DELAY] key or [REVERB] key

to select a patch for the send/return effect.

The display changes and shows the currently selected patch

of the selected effect (chorus/delay or reverb).

2. Turn the dial to select the patch you want to use.

You can also select a patch by using the PATCH SELECT

[Q]/[W] keys in the effect section.

When you have selected the patch, press the [EXIT] key.

3. Press the [TRACK PARAMETER] key in the track parameter section and use the cursor up/down keys to bring the following indication onto the display.

• Adjusting the chorus/delay send level

TR1

CHO SEND 0

• Adjusting the reverb send level

TR1

REV SEND 0

4. Press the status key for the audio track or the drum track to which you want to apply the effect.

5. Turn the dial to select the effect depth.

Higher values result in more effect depth (stronger effect).

The range and default values for the parameters are shown

below.

•CHORUS/DELAY SEND: 0 - 100 (default: 0)

•REVERB SEND: 0 - 100 (default: 0)

ZOOM MRS-802

72