Powering Up

To ensure that all the devices you just connected to the V3 install correctly, you need to power up each device one at a time. Follow these steps carefully.

1 Plug in the modem’s Power Supply, and turn on the modem’s on/off switch if it has one.

Plug the modem’s power cube into a power outlet.

Wait for one-two minutes so that you are sure the modem has completed its power up process before proceeding to Step 2.

2 Plug in the V3’s Power Supply.

Plug the included power cube into a power outlet and then into the V3’s power (PWR) jack.

Wait for one-two minutes so that you are sure the V3 has completed its power up process before proceeding to Step 3.

Note: Use only the power cube shipped with the V3 or you may cause damage to your hardware.

3 Turn the computer on.

If you are using USB, a Found New Hardware box should display, showing the progress of the installation. Follow the prompts.

Windows XP users: You may see Hardware Installation disclaimer boxes regarding Windows logo testing. You can safely disregard these messages and click Continue Anyway.

Windows 2000 users: You may see a Digital Signature Not Found dialog box. You can safely disregard this message and click Yes.

Windows 98/Me users: Restart your computer if you are prompted to do so.

Chapter 1: Installation Instructions

11

Page 11
Image 11
Zoom Zoom V3 manual Powering Up, Plug in the V3’s Power Supply