Prestige
Step 7. Use “put” to transfer files from the Prestige to the computer, for example, “put config.rom rom- 0” transfers the configuration file “config.rom” on your computer to the Prestige. See earlier in this chapter for more information on filename conventions.
Step 8. Enter “quit” to exit the ftp prompt. The Prestige will automatically restart after a successful restore process.
11.3.2 Restore Using FTP Session Example
ftp> put config.rom
150 Opening data connection for STOR
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit
Figure 11-8 Restore Using FTP Session Example
Refer to section 11.2.5 to read about configurations that disallow TFTP and FTP over WAN.
11.3.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.
Step 1. Display menu 24.6 and enter “y” at the following screen.
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Figure 11-9 System Maintenance – Restore Configuration
Step 2. The following screen indicates that the Xmodem download has started.
Starting XMODEM download (CRC mode) ...
CCCCCCCCC
Figure 11-10 System Maintenance – Starting Xmodem Download Screen
Step 3. Run the HyperTerminal program by clicking Transfer, then Send File as shown in the following screen.
Firmware and Configuration File Maintenance |