Prestige 650R-31/33 ADSL Router

4.2Remote Node Setup

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network Layer Options as shown next.

Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.

Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press [ENTER] to display Menu 11.3 – Remote Node Network Layer Options.

Menu 11.3 - Remote Node Network Layer Options

IP Options:

Bridge Options:

IP Address Assignment = Dynamic

Ethernet Addr Timeout(min)= N/A

Rem IP Addr = 0.0.0.0

 

Rem Subnet Mask= 0.0.0.0

 

My WAN Addr= N/A

 

NAT= None

 

Address Mapping Set= N/A

 

Metric= 2

 

Private= No

 

RIP Direction= None

 

Version= RIP-1

 

Multicast= None

 

IP Policies=

 

Enter here to CONFIRM or ESC to CANCEL:

Figure 4-3 Remote Node Network Layer Options

The next table explains fields in Menu 11.3 – Remote Node Network Layer Options.

Table 4-2 Remote Node Network Layer Options

FIELD

DESCRIPTION

EXAMPLE

 

 

 

IP Address

Press [SPACE BAR] and then [ENTER] to select Dynamic if the

Dynamic

Assignment

remote node is using a dynamically assigned IP address or Static if

 

 

it is using a static (fixed) IP address. You will only be able to

 

 

configure this in the ISP node (also the one you configure in menu

 

 

4), all other nodes are set to Static.

 

Rem IP Addr

This is the IP address you entered in the previous menu.

 

 

 

 

Rem Subnet Mask

Type the subnet mask assigned to the remote node.

 

 

 

 

4-6

Remote Node Configuration