Prestige
Menu 11.3 - Remote Node Network Layer Options
IP Options: | Bridge Options: |
IP Address Assignment= Static | Ethernet Addr Timeout (min)= 0 |
Rem IP Addr: 0.0.0.0 |
|
Rem Subnet Mask= 0.0.0.0 |
|
My WAN Addr= 0.0.0.0 |
|
NAT= Full Feature |
|
Address Mapping Set=2 |
|
Metric= 2 |
|
Private= No |
|
RIP Direction= Both |
|
Version= |
|
Multicast= |
|
IP Policies= |
|
Press ENTER to Confirm or ESC to Cancel:
Figure 6-1 Menu 11.3 – Remote Node Bridging Options
| Table |
|
|
FIELD | DESCRIPTION |
|
|
Bridge (menu 11.1) | Make sure this field is set to Yes. |
|
|
Edit IP/Bridge (menu | Press [SPACE BAR] to select Yes and press [ENTER] to display menu 11.3. |
11.1) |
|
Ethernet Addr Timeout | Type the time (in minutes) for the Prestige to retain the Ethernet Address |
(min.) (menu 11.3) | information in its internal tables while the line is down. If this information is |
| retained, your Prestige will not have to recompile the tables when the line |
| comes back up. |
|
|
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
6.2.2 Bridge Static Route Setup
Similar to network layer static routes, a bridging static route tells the Prestige the route to a node before a connection is established. You configure bridge static routes in menu 12.3.1 (go to menu 12, choose option 3, then choose a static route to edit) as shown next.
Bridging Setup |