Chapter 25 Access Control

Figure 96 Access Control: SNMP

The following table describes the labels in this screen.

Table 65 Access Control: SNMP

LABEL

DESCRIPTION

Get

Enter the get community, which is the password for the incoming Get- and GetNext-

Community

requests from the management station.

 

 

Set

Enter the set community, which is the password for incoming Set- requests from the

Community

management station.

 

 

Trap

Enter the trap community, which is the password sent with each trap to the SNMP

Community

manager.

 

 

Trap

Enter the IP addresses of up to four stations to send your SNMP traps to.

Destination

 

 

 

Apply

Click Apply to save your changes to the switch’s run-time memory. The switch loses

 

these changes if it is turned off or loses power, so use the Save link on the top

 

navigation panel to save your changes to the non-volatile memory when you are

 

done configuring.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

25.3.4 Setting Up Login Accounts

Up to five people (one administrator and four non-administrators) may access the switch via web configurator at any one time.

1An administrator is someone who can both view and configure switch changes. The username for the administrator is always admin. The default administrator password is 1234.

"It is highly recommended that you change the default administrator password ("1234").

2A non-administrator (username is something other than admin) is someone who can view but not configure switch changes.

178

 

GS-3012/GS-3012F User’s Guide