Chapter 31 Configure Clone

The following table describes the labels in this screen.

Table 79 Configure Clone

LABEL

DESCRIPTION

Source/

Enter the source port under the Source label. This port’s attributes are copied.

Destination

Enter the destination port or ports under the Destination label. These are the ports

Port

which are going to have the same attributes as the source port. You can enter

 

individual ports separated by a comma or a range of ports by using a dash.

 

Example:

 

• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.

 

• 2-6indicates that ports 2 through 6 are the destination ports.

 

 

Basic Setting

Select which port settings (you configured in the Basic Setting menus) should be

 

copied to the destination port(s).

 

 

Advanced

Select which port settings (you configured in the Advanced Application menus)

Application

should be copied to the destination ports.

 

 

Apply

Click Apply to save your changes to the switch’s run-time memory. The switch loses

 

these changes if it is turned off or loses power, so use the Save link on the top

 

navigation panel to save your changes to the non-volatile memory when you are done

 

configuring.

 

 

Cancel

Click Cancel to reset the fields.

 

 

204

 

GS-3012/GS-3012F User’s Guide