ZyXEL Communications GS-3012 Series, GS-3012F Series manual 179

Chapter 25 Access Control

Click Access Control from the navigation panel and then click Logins from this screen.

Figure 97 Access Control: Logins

The following table describes the labels in this screen.

Table 66 Access Control: Logins

LABELDESCRIPTION

Administrator

This is the default administrator account with the “admin” user name. You cannot change the default administrator user name. Only the administrator has read/write access.

Old Password	Type the existing system password ("1234" is the default password when
	shipped).
New Password	Enter your new system password.
Retype to confirm	Retype your new system password for confirmation

Edit Logins

You may configure passwords for up to four users. These users have read-only access. You can give users higher privileges via the CLI. For more information on assigning privileges see Chapter 32 on page 207.

User Name	Set a user name (up to 32 ASCII characters long).
Password	Enter your new system password for the user name above.
Retype to confirm	Retype your new system password for confirmation
Apply	Click Apply to save your changes to the switch’s run-time memory. The switch
	loses these changes if it is turned off or loses power, so use the Save link on the
	top navigation panel to save your changes to the non-volatile memory when you
	are done configuring.
Cancel	Click Cancel to begin configuring this screen afresh.

	179
GS-3012/GS-3012F User’s Guide