Chapter 34 IEEE 802.1Q Tagged VLAN Commands
34.4.3 Show GVRP
Syntax:
show vlan1q gvrp
This command shows the switch’s GVRP settings.
An example is shown next.
Figure 161 show gvrp Command Example
sysname# show vlan1q gvrp GVRP Support
gvrpEnable = YES
34.4.4 Enable GVRP
Syntax:
vlan1q gvrp
This command turns on GVRP in order to propagate VLAN information beyond the switch.
34.4.5 Disable GVRP
Syntax:
no vlan1q gvrp
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
34.5 Port VLAN Commands
You must configure the switch port VLAN settings in
34.5.1 Set Port VID
Syntax:
pvid <VID>
where
<VID> = Specifies the VLAN number between 1 and 4094
This command sets the default VLAN ID on the port(s).
The following example sets the default VID to 200 on ports 1 to 5.
260 |
| |
| ||
|
|
|