
Chapter 7 Network Setting
Table 37 RIP (continued)
LABEL | DESCRIPTION |
Authentication | Use this option to enable or disable RIP authentication. |
|
|
Authentication ID | Enter the authentication ID to use for RIP authentication. |
|
|
Authentication | Enter the authentication key to use for RIP authentication. |
Key |
|
|
|
7.14 Port Forwarding
Use these settings to forward incoming service requests to the ports on your local network.
Note: Make sure you did not configure a DMZ host in the Network Setting > NAT > DMZ screen if you want to make the settings of this screen work.
Click Network Setting > NAT > Port Forwarding to open this screen as shown next.
Figure 55 Port Forwarding Screen
This screen contains the following fields:
Table 38 Port Forwarding
LABEL | DESCRIPTION |
Active | This indicates whether the port forwarding rule is active or not. |
|
|
Name | The displays the name of the port forwarding rule. |
|
|
Protocol | This displays the protocol to which the port forwarding rule applies. |
|
|
Incoming Port(s) |
|
|
|
Start Port | This displays the starting port number for incoming traffic for the port forwarding |
| rule. |
|
|
End Port | This displays the ending port number for incoming traffic for the port forwarding |
| rule. |
|
|
Forward Port(s) |
|
|
|
Start Port | This field displays the beginning of the range of port numbers forwarded by this |
| rule. |
|
|
End Port | This field displays the end of the range of port numbers forwarded by this rule. If |
| it is the same as the Start Port, only one port number is forwarded. |
|
|
Server IP | This displays the IP address of the server to which packet for the selected port(s) |
| are forwarded. |
|
|
Delete | Click this to delete a specified rule. |
|
|
Wizard | Click this to open the port forwarding “wizard”. |
|
|
Add | Click this to add a new port forwarding rule. |
|
|
OK | Click this to save any changes made to the port forwarding list. |
|
|
| 107 |
WiMAX Device Configuration User’s Guide | |
|
|