
Chapter 10 The VoIP Account Screens
Table 73 Feature (continued)
LABEL | DESCRIPTION | |
MWI (Message | Select this to enable Message Waiting Indicator (MWI) function for this SIP | |
Waiting | account specified in Section 10.4 on page 163. When there is at least one new | |
Indication) | voice mail for the SIP account, the voice LED turns yellow and the WiMAX | |
| ||
| Device sends a beeping tone to the phone while user | |
| make calls. | |
|
| |
DTMF |
| |
|
| |
DTMF | Control how the WiMAX Device handles the DTMF tone relay to the | |
| communication peer. The DTMF tone is generated by the phone when you push | |
| its digit buttons during a call. One application is to send numbers when trying | |
| to do IVR (Interactive Voice Response) service with server. | |
| You should use the same mode as your VoIP service provider. The choices are: | |
| • | |
| DTMF tones in RTP packets. | |
| • In Band - Send the DTMF tones in the voice data stream. This works best | |
| when you are using a codec that does not use compression (like G.711). | |
| Codecs that use compression (like G.729) can distort the tones. | |
|
| |
SIP INFO | Select this to have the WiMAX Device send the DTMF tones in SIP messages. | |
|
| |
Call Forward Setting |
| |
|
| |
Unconditional | Select this if you want the WiMAX Device to forward all incoming calls to the | |
CF, | specified phone number, regardless of other rules in this Call Forward Setting | |
Unconditional | section. Specify the phone number in the Unconditional CF Target field. | |
CF Target | ||
| ||
| Note: The Unconditional CF function should be used very carefully, since | |
| enabling this function makes the WiMAX Device forward all incoming | |
| calls to another phone number, so the user would never know if there are | |
| any incoming calls. | |
|
| |
Busy CF, | Select this if you want the WiMAX Device to forward incoming calls to the | |
Busy CF Target | specified phone number if the phone port is busy. Specify the phone number in | |
| the Busy CF Target field. If you have call waiting, the incoming call is | |
| forwarded to the specified phone number if you reject or ignore the second | |
| incoming call. | |
|
| |
No Answer CF, | Select this if you want the WiMAX Device to forward incoming calls to the | |
No Answer CF | specified phone number if the call is unanswered. Specify the phone number in | |
Target, No | the No Answer CF Target field on the right. Specify the time to wait before | |
Answer CF | ||
forwarding incoming calls in the No Answer CF Waiting Time field. | ||
Waiting Time | ||
|
| |
Call Waiting Setting |
| |
|
| |
Call Waiting | Select this to enable call waiting for this SIP account on the WiMAX Device. | |
|
| |
Call Waiting | Enter time to wait before rejecting a call when call waiting is enabled. | |
Reject Time |
| |
|
|
10.6 Dialing
Click VoIP > Account 1 (or Account 2) > Dialing to configure dialing timeout values.
Figure 96 Dialing166 |
|
WiMAX Device Configuration User’s Guide | |
|
|