
Chapter 3 Setup Wizard
The following table describes the labels in this screen.
Table 6 Setup Wizard > WiMAX Frequency Settings
LABEL | DESCRIPTION |
Setting Type | Select the WiMAX frequency setting type from the list. |
| • By Range - Select this to set up the frequency based on a range of |
| MHz. |
| • By List - Select this to set up the frequency on an individual MHz basis. |
| You can add multiple MHz values to the list. |
|
|
Step | Enter the increments in MHz by which to increase the frequency range. |
| Note: This field only appears when you select By Range under Setting Type. |
|
|
Start Frequency | Enter the frequency value at the beginning of the frequency range to use. |
| The frequency is increased in increments equal to the Step value until the |
| End Frequency is reached, at which time the cycle starts over with the |
| Start Frequency. |
| Note: This field only appears when you select By Range under Setting Type. |
|
|
End Frequency | Enter the frequency value at the end of the frequency range to use. |
| Note: This field only appears when you select By Range under Setting Type. |
|
|
Bandwidth | Set the frequency bandwidth in MHz that this WiMAX Device uses. |
|
|
# | This is an index number for enumeration purposes only. |
|
|
Frequency (MHz) | Displays the frequency MHz for the item in the list. |
|
|
Total Num | Displays the total number of items in the list. |
|
|
Delete | Click this to remove an item from the list. |
|
|
Add | Click this to add an item to the list. |
|
|
OK | Click this to save an newly added item to the list. |
|
|
# | This is an index number for enumeration purposes only. |
|
|
Band Start (KHz) | Indicates the beginning of the frequency band in KHz. |
|
|
Band End (KHz) | Indicates the end of the frequency band in KHz. |
|
|
Total Num | Displays the total number of items in the list. |
|
|
Back | Click to display the previous screen. |
|
|
Next | Click to proceed to the next screen. |
|
|
3.1.4 WiMAX Authentication Settings
The WiMAX Authentication Settings screen allows you to configure how your WiMAX Device logs into the service provider’s network.
Note: These settings should be provided by your ISP.
Note: The EAP supplicant settings on this screen vary depending on the authentication mode your select.
28 |
|
WiMAX Device Configuration User’s Guide | |
|
|