
Chapter 18 Configuration
Figure 139 RMON Configuration: History Config.: New
The following table describes the labels in this screen.
Table 100 RMON Configuration: History Config.: New
| LABEL | DESCRIPTION | 
| Active | Select Yes to enable this rule. Select No to disable this rule. | 
| 
 | 
 | 
| Data Source | Select the port of the switch that the EMS polls for data. The probe sends data from | 
| 
 | this port. | 
| 
 | 
 | 
| Interval | Enter the time (in seconds) between data samplings. | 
| 
 | 
 | 
| Bucket | Specify the number of data samplings (between 1 and 100) the network manager | 
| Requested | requests the probe to store. | 
| 
 | 
 | 
| Owner | Enter a descriptive name of the application that creates this entry. You can use  | 
| 
 | printable characters. Spaces are allowed. | 
| 
 | 
 | 
| OK | Click this to save the settings and close this screen. | 
| 
 | 
 | 
| Cancel | Click this to discard all changes and close the screen. | 
| 
 | 
 | 
18.3 Event Config
Use the Event Config screen to configure the actions that a switch takes when an alarm is triggered. To open this screen, 
| 
 | 193 | 
| NetAtlas Workgroup User’s Guide | |
| 
 | 
 |