ZyXEL G-1000 v2 User’s Guide

Figure 4 Change Password Screen

6On this screen you can access the wizard setup or the advanced setup.

Click Go to Advanced setup to access the status screen of the web configurator.

Note: The management session automatically times out when the time period set in the Administrator Inactivity Timer field expires (default five minutes). Simply log back into the G-1000 v2 if this happens to you.

2.3 Resetting the G-1000 v2

If you forget your password or cannot access the web configurator, you will need to reload the factory-default configuration file or use the RESET button on the top panel of the G-1000 v2. Uploading this configuration file replaces the current configuration file with the factory- default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to 1234.

2.3.1 .Procedure To Use The Reset Button

Make sure the SYS light is on (not blinking) before you begin this procedure.

1Press the RESET button for ten seconds or until the SYS light starts to blink, and then release it. If the SYS light begins to blink, the defaults have been restored and the G-1000 v2 restarts. Otherwise, go to step 2.

2Turn the G-1000 v2 off.

3While pressing the RESET button, turn the G-1000 v2 on.

4Continue to hold the RESET button. The SYS light will begin to blink and flicker very quickly after about 20 seconds. This indicates that the defaults have been restored and the G-1000 v2 is now restarting.

5Release the RESET button and wait for the G-1000 v2 to finish restarting.

34

Chapter 2 Introducing the Web Configurator