ZyXEL
The following table describes the labels in this screen.
Table 22 Wireless LAN: Advanced
LABEL | DESCRIPTION |
|
|
Roaming Configuration | |
|
|
Enable | Select this checkbox to enable roaming on the |
Roaming | 1000 v2s on the same subnet. |
| Note: All APs on the same subnet and the wireless stations must |
| have the same SSID to allow roaming. |
Port | Enter the port number to communicate roaming information between APs. The port |
| number must be the same on all APs. The default is 3517. Make sure this port is not |
| used by other services. |
Wireless Advanced Setup | |
|
|
RTS/CTS | Enter a value between 0 and 2432. If you select the Enable 802.11g+ mode |
Threshold | checkbox, this field is grayed out and the |
Fragmentation | It is the maximum data fragment size that can be sent. Enter a value between 256 and |
Threshold | 2432. If you select the Enable 802.11g+ mode checkbox, this field is grayed out and |
| the |
Enable Intra- | |
BSS Traffic | Select this check box to enable |
Enable | Select this check box to enable the Breathing LED, also known as the ZyAIR LED. |
Breathing LED | The blue ZyAIR LED is on when the |
| data is being transmitted to/from its wireless stations. |
| Clear the check box to turn this LED off even when the |
| being transmitted/received. |
Number of | Enter a number from 1 to 32, to limit the number of wireless devices which can |
Wireless | communicate in your wireless network. |
Stations |
|
Allowed |
|
802.11 Mode | Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to |
| associate with the |
| Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to |
| associate with the |
| Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices |
| to associate with the |
| reduced. |
Apply | Click Apply to save your changes back to the |
|
|
Reset | Click Reset to reload the previous configuration for this screen. |
|
|
62 | Chapter 4 Wireless LAN |