ZyXEL G-1000 v2 User’s Guide

Table 49 Menu 24.2.1 System Maintenance: Information

FIELD

DESCRIPTION

 

 

ZyNOS F/W Version

Refers to the ZyNOS (ZyXEL Network Operating System) system firmware

 

version. ZyNOS is a registered trademark of ZyXEL Communications

 

Corporation.

Country Code

Refers to the country code of the firmware.

 

 

LAN

 

 

 

Ethernet Address

Refers to the Ethernet MAC (Media Access Control) of your G-1000 v2.

 

 

IP Address

This is the IP address of the G-1000 v2 in dotted decimal notation.

 

 

IP Mask

This shows the subnet mask of the G-1000 v2.

 

 

DHCP

This field shows the DHCP setting of the G-1000 v2.

 

 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

15.2.2 Console Port Speed

Note: The console port is internal and reserved for technician use only.

You can set up different port speeds for the console port through Menu 24.2.2 – System Maintenance – Console Port Speed. Your G-1000 v2 supports 9600 (default), 19200, 38400, 57600 and 115200 bps console port speeds. Press [SPACE BAR] and then [ENTER] to select the desired speed in menu 24.2.2, as shown in the following figure.

Figure 64 Menu 24.2.2 System Maintenance: Change Console Port Speed

Menu 24.2.2 – System Maintenance – Change Console Port Speed

Console Port Speed: 9600

Press ENTER to Confirm or ESC to Cancel:

After you changed the console port speed on your G-1000 v2, you must also make the same change to the console port speed parameter of your communication software.

15.3 Log and Trace

To get to the log and trace information:

1Enter 24 to display Menu 24 – System Maintenance.

2Enter 3 to display Menu 24.3 – Log and Trace.

3From this menu you have one choice as shown in the next figure:

116

Chapter 15 System Information and Diagnosis