ZyXEL
Menu 24.5 – Backup Configuration
To transfer the configuration file to your workstation, follow the procedure below:
1.Launch the FTP client on your workstation.
2.Type "open" and the IP address of your router. Then type "root" and SMT password as requested.
3.Locate the
4.Type ‘get
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain in the menu to back up using TFTP), please see your router manual.
Press ENTER to Exit:
16.2.2 Using the FTP command from the DOS Prompt1Launch the FTP client on your computer.
2Enter “open” and the IP address of your
3Press [ENTER] when prompted for a username.
4Enter “root” and your SMT password as requested. The default is 1234.
5Enter “bin” to set transfer mode to binary.
6Use “get” to transfer files from the
7Enter “quit” to exit the FTP prompt.
Figure 69 FTP Session Example331 Enter PASS command Password:
230 Logged in ftp> bin
200 Type I OK
ftp> get
150 Opening data connection for STOR ras
226 File received OK
ftp: 327680 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Chapter 16 Firmware and Configuration File Maintenance | 121 |