ZyXEL Communications ZyXEL G-1000 v2 Menu 3 – LAN Setup, Menu 3.5 – Wireless LAN Setup

ZyXEL G-1000 v2 User’s Guide

Follow the instructions in the following table on how to configure the fields in this menu.

Table 41 Menu 3.2 TCP/IP Setup

FIELD	DESCRIPTION
IP Address	Press [SPACE BAR] and then [ENTER] to select Dynamic to have the G-1000 v2
Assignment	obtain an IP address from a DHCP server. You must know the IP address assigned
	to the G-1000 v2 (by the DHCP server) to access the G-1000 v2 again.
	Select Static to give the G-1000 v2 a fixed, unique IP address. Enter a subnet mask
	appropriate to your network and the gateway IP address if applicable.
IP Address	Enter the (LAN) IP address of your G-1000 v2 in dotted decimal notation
IP Subnet Mask	Your G-1000 v2 will automatically calculate the subnet mask based on the IP
	address that you assign. Unless you are implementing subnetting, use the subnet
	mask computed by the G-1000 v2.
Gateway IP	Type the IP address of the gateway. The gateway is an immediate neighbor of your
Address	G-1000 v2 that will forward the packet to the destination. On the LAN, the gateway
	must be a router on the same network segment as your G-1000 v2.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your configuration, or press [ESC] at any time to cancel.

12.3 Wireless LAN Setup

Use menu 3.5 to set up your G-1000 v2 as the wireless access point. To edit menu 3.5, enter 3 from the main menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5 and then press [ENTER] to display Menu 3.5 – Wireless LAN Setup as shown next.

Figure 49 Menu 3.5 Wireless LAN Setup

	Menu 3.5 - Wireless LAN Setup
ESSID= ZyXEL
Hide ESSID= No		Edit MAC Address Filter= No
Channel	ID= CH06 2437MHz
RTS Threshold= 2432		Edit Roaming Configuration= No
Frag. Threshold= 2432		Breathing LED= No
WEP Encryption= 64-bit WEP		802.11 Mode= Mixed
Default Key= 1
Key1=	********	Output Power= 17 dBm
Key2=	********	Block Intra-BSS Traffic= No
Key3=	********
Key4=	********

Authen. Method= Auto

Press ENTER to Confirm or ESC to Cancel:

Note: In the SMT, the ESSID is referred to as SSID. Both of them refer to the same ID for the G-1000 v2.

100 Chapter 12 LAN Setup