DeWalt DPH3100 instruction manual Troubleshooting Codes

English

(Troubleshooting Codes cont.)

Code	possible cause	POSSIBLE SOLUTION
9	Spray wand not in high pressure.	See Spray Wand Nozzles under Operation.
10	Low water supply.	Water supply must be at least 5 GPM @ 20 PSI (138 kPa).
11	Leak at high-pressure hose fitting.	Repair leak. Apply sealant tape if necessary.
12	Nozzle obstructed.	See Nozzle Cleaning under Maintenance.
13	Water filter screen clogged.	Remove and clean filter.
14	Air in hose.	Turn off the engine, then the water source. Disconnect the
		water source from the pump inlet and turn the water source
		on to remove all air from the hose. When there is a steady
		stream of water present, turn water source off. Reconnect­
		water source to pump inlet and turn on water­ source. Squeeze
		trigger to remove­ remain­ing­ air.
15	Choke lever in the Choke position.	Move choke to the No Choke posi­tion­.
16	High-pressure hose is too long.	Use high-pressure hose under 100 feet (30.48 m). Lengthen water
		supply hose instead of high-pressure hose.
17	Spray wand not in low pressure.	See Spray Wand Nozzles under Operation.
18	Chemical filter clogged.	Clean filter.
19	Chemical screen not in cleaning solution.	Make sure end of chemical hose is fully submerged into cleaning
		solution.
20	Chemical too thick.	Dilute chemical. Chemical should be the same consistency as water.
21	Worn seal or packing.	Have parts cleaned or replaced by authorized service center.
22	Chemical build up in chemical injector.	Have replaced by an authorized service center.
23	Worn or obstructed valves.	Have replaced by authorized service center.
24	Worn unloader piston.	Have replaced by authorized service center.

18