Agilent Technologies 5951-2826 manual Output 705TRAN on Output 705INPUT on, Constant Current CC

80 OUTPUT 705;"TRAN ON

90 OUTPUT 705;"INPUT ON"

	.
	.
	.
	.
	200 OUTPUT 705;"*TRG"
	210 END
Line 10:	Turns off Electronic Load input.
Line 20:	Selects the CR mode.
Line 30:	Selects the main resistance level to 10 ohms.
Line 40:	Sets the transient resistance level to 5 ohms. Remember in the 1 to 1k range, the transient resistance level
	must be set to a lower level than the main resistance level.
Line 50:	Selects the GPIB as the trigger source.
Line 60:	Sets the current slew rate to the fastest rate. Remember that in the middle range, the resistance slew rate
	is programmed in amps/second.
Line 70:	Selects pulsed transient operation and sets the pulse width to 1 millisecond.
Line 80:	Turns on the transient generator.
Line 90	Turns on Electronic Load input.
Line 100
to	Other commands are executed.
Line 190

Line 200: The *TRG command generates a 1 millisecond pulse at the Electronic load input.

Table 5-1. Remote Programming Ranges

Function

Constant Current (CC)

Set Range

Low Range

High Range

Set Main Level

Low Range

High Range

Set Slew Rate

Low Range

High Range

Set Transient Level

*Set Triggered Level

HPSL Command

(Short Form)

"CURR:RANG value"

’CURR value"

"CURR:SLEW value"

.

"CURR:TLEV value" "CURR:TRIG value"

Range of Values
6060B	6063B
³ 0 and £ 6 A	³ 0 and £1 A
> 6 and £ 60 A	> 1 and £ 10 A
0 to 6 A	0 to l A
0 to 60 A	0 to 10 A
100 to 500,000 A/s	1.7 to 83,000 A/s
1000 to 5,000,000 A/s	17 to 830,000 A/s

Same as CC main level

Same as CC main level

72 Remote Operation