IDLE CONTROL OPERATION
The Idle Control circuit is designed to extend engine life and improve fuel usage by slowing the engine down to approximately 2000 RPM in a “No Load” condition. The noise is also greatly reduced during this condition.
When power is required from the generator an electronic control module automatically senses current flow in the electrical outlet and allows the engine to return to full speed or standard operating condition. Likewise, when the load is removed, the generator will automatically return to the idle condition after a
A convenient switch is mounted in the control panel for easy access and will disable the Idle Control circuitry when in the off position.
IDLE CONTROL TROUBLE SHOOTING
PROBLEM |
| POSSIBLE CAUSE |
| SOLUTION |
Unit will not idle |
| Control panel switch not on |
| Turn to idle on position |
|
|
|
|
|
|
| Load plugged into receptacle |
| Unplug load |
|
|
|
|
|
|
| Poor connection or faulty cord |
| Check & repair |
|
|
|
|
|
|
| Bad I.C. module; Bad |
| Replace |
|
| or solenoids; Bad stator |
|
|
|
|
| Consult dealer | |
|
|
|
| |
Unit idles even with load plugged in |
| Load not heavy enough |
| Turn idle switch to off position |
|
|
|
|
|
|
|
|
| Increase load |
|
|
|
|
|
|
| Bad I.C. module |
| Replace |
|
|
|
|
|
|
|
|
| Consult dealer |
Unit tries to idle but won’t stay latched |
|
| Reset magnet or solenoid position for | |
|
| incorrect |
| 2000 RPM idle speed |
|
|
|
|
|
|
|
|
| Consult dealer |
|
| Flapper bracket loose or bent |
| Tighten or straighten |
|
|
|
|
|
|
|
|
| Replace flapper. Readjust to 2000 RPM |
|
|
|
|
|
|
| Engine not running smoothly |
| Adjust carburetor |
|
|
|
|
|
|
|
|
| Consult dealer |
|
|
|
|
|
|
|
|
10 | English | |
|
|
|
|
|
|