MAINTENANCE |
| SERVICE INFORMATION |
|
|
|
GENERATOR: Brushes
The brushes in the generator should be inspected once every year for chips and cracks. Brushes should be replaced when they are worn to 1/4 inch (7mm).
NOTE: Replace brushes in sets only, never separately.
INSPECTING THE BRUSHES:
1.Remove cover plate (L).
2.Remove 4 stator bolts (O) and endbell.
3.Disconnect the green
4.Remove brush mounting screws (M).
5.Slide brushes (N) from holders.
6.Replace if worn to 1/4 inch (7mm).
7.Do not over tighten screws.
NOTE: Replace only with brushes specified in parts list. Other brushes may appear to be identical but may have completely different mechanical and electrical characteristics.
EXCITING THE GENERATOR:
NOTE: If your generator is a brushless unit please contact your local service center or the Coleman Powermate Service Department for assistance with exciting your generator.
If there is a loss of residual magnetism (voltage will not build up), it may be necessary to
1.Use a
2.Remove the brush cover.
3.Start the engine with no load connected to the generator.
4.Attach the
shown. Remove as soon as voltage builds up. To measure voltage, use a
HEAT SHIELD:
Inspect to ensure that all heat shields and heat deflectors are intact and in place.
ENGINE: Carburetor Icing
During the winter months, rare atmospheric conditions may develop which will cause an icing condition in the carburetor. If this develops, the engine may run rough, loose power, and may stall. This temporary condition can be overcome by deflecting some of the hot air from the engine over the carburetor area.
NOTE: Refer to the engine manufacturer's manual for service and maintenance of the engine.
CONTACT THE COLEMAN POWERMATE CUSTOMER SERVICE DEPARTMENT AT
to obtain warranty service
information or to order replacement parts or accessories.
HOW TO ORDER REPLACEMENT PARTS
Even quality built equipment such as the Coleman Powermate electric generator you have purchased, might need occasional replacement parts to maintain it in good condition over the years. To order replacement parts, please give the following information:
1.Model No. and Serial No. and all specifications shown on the Model No./Serial No. plate.
2.Part number or numbers as shown in the Parts List section of this manual.
3.A brief description of the trouble with the generator.
NOTE: If replacement parts are required for the engine, contact one of the engine manufacturer's service centers.
Coleman Powermate, Inc.
4970 Airport Road
P. O. Box 6001
Kearney, NE 68848
|
|
|
English | 11 | |
|
|
|