Konica Minolta 752 operation manual Print preference set screen 3/7 will appear

4-3.How To Operate Maintenance Mode

(6)Touch the key on the right of the setting item, then touch [$] / [%] on the lower part of the screen to set the following items.

DENSITY	: Adjust the density of an image.
	Selectable from -7 to 7.
	Setting a negative value will make the den-
	sity lighter, and a positive value, darker.
CONTRAST	: Adjust the contrast of an image.
	Selectable from -7 to 7.
	Setting a negative value will make the con-
	trast lower, and a positive value, higher.
SMOOTH TYPE : Sets the smoothing type of an image.
SMOOTH TYPE		Settings
OFF		Does not perform the magnification
		interpolation.
1		Performs the Biliner interpolation.
2-6		Performs the Cubic Spline interpo-
		lation.
		Increasing the value will smooth an
		image greater.

7Does not perform the magnification interpolation. But prints out in the MAGNIFICATION setting. When you wish to change this setting, ask a service person.

DEFAULT TRAY: Sets whether the upper or lower tray is pri- oritized when the tray is not specified from the diagnostic device.

(7)After the settings are complete, touch on the upper part of the screen once.

The print preference set screen (3/7) will appear.

(8)Touch the key on the right of the setting item, then touch the numeric keys on the lower part of the screen to set the following items.

MAX DENSITY : Sets the maximum density of an image.

MIN DENSITY	: Sets the minimum density of an image.
Lo	: (Not used for the current version.)
La	: (Not used for the current version.)
SORTER	: Sets the bin in the sorter (option) into which the
	film is discharged.

(9)After the settings are complete, touch on the upper part of the screen once.

The print preference set screen (4/7) will appear.

DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6 39