Kodak 9150DC, 9125DC Feeder table, Down/Set, Custom functions, Clean Print Head, Scan monitor

Feeder table	The Feeder Table adjustment buttons allow you to raise and lower the
	feeder table to accommodate different batch sizes. The feeder table
	must be empty to move to a new batch size position.
	Down/Set
	•	Down: lowers the feeder table.
	• Set: load a standard batch of documents, lower the skimmer and wait
		until the table is raised. Press and hold the Down/Set button for 2
		seconds.
	Up — raises the feeder table. If the feeder table has documents in it,
	the Up button performs no function.
Custom functions	Two custom functions (F1 and F2) can be assigned via the Ngenuity
	Operator Utility. Available functions are: Feed Test Batch, Page Eject
	and Clean Print Head.
	By default, F1 is assigned to Feed Test Batch and F2 is assigned to
	Page Eject. See the section entitled, “Ngenuity Operator Utility” later in
	the chapter for more information.
Scan monitor	The Scan Monitor indicates that an error has occurred during scanning.
	The Scan Monitor indicators are lit in yellow.
	Error — indicates that an error exists that is not covered by one of the
	other indicators. When an error is indicated, refer to the scanning
	application for more information.
	Cover — indicates that the scanner cover is open. Carefully close the
	scanner cover.
	If this error occurs during scanning, press Clear/Restart after you have
	securely closed the cover.
	Paper Jam — indicates a document jam within the scanner. Open the
	scanner cover, remove any jammed documents and close the cover.
	Press Clear/Restart to continue scanning.
	Misfeed — indicates that a skimmer timeout or feeder jam has
	occurred.
	•	Skimmer timeout: the skimmer is active, but the document to be
		scanned did not move out of the feeder table (commonly due to roller
		slippage).
	•	Feeder jam: the document to be scanned is fed but does not reach
		the scanner transport within the expected transit time.

A-61662 October 2011 4-5