Kodak 9090DB, 9125DC, 9150DC, 9090DC manual

Scanner Self Test — displays the results of the internal scanner fault monitoring. A green checkmark icon indicates that no scanner faults were detected.

A red X icon indicates one or more scanner faults were detected. The text box will list each fault detected.

If the Self Test monitor displays a fault(s), power cycle the scanner and check the Scanner Self Test monitor again. If the problem persists, refer to Chapter 7, Troubleshooting.

Maintenance monitor — this section of the Home screen displays any scanner maintenance and the type of maintenance needed (i.e., clean transport, replace feed rollers, etc.). Monitored maintenance includes:

•Clean feed rollers

•Clean transport

•Clean optics (e.g., imaging guides, camera glass covers, sensors)

•Replace feed rollers

•Calibration of the front/back camera

•Replace imprinter ink cartridge (if optional imprinter is installed)

The Maintenance monitor also displays when or how soon specific maintenance should occur in the form of a bar graph. See Chapter 6, Maintenance for detailed maintenance procedures.

When a maintenance item’s pre-set interval expires, the scanner’s Maintenance indicator will blink slowly, the icon will change from blue to yellow and the bar graph will be red. In addition, an alert will be displayed (yellow triangle).

NOTE: The presence of a red bar graph will not disrupt or stop the scanner.

4-14 A-61662 October 2011