Maintenance
Replacing the ink cartridge 1. Turn off the scanner and power down the host PC.
2.Remove the front (or back) imprinter from the scanner. See the sec- tions entitled, “Removing the front imprinter” or “Removing the back imprinter” earlier in this appendix for instructions.
3.Remove the ink cartridge by grasping the ink cartridge holder and pulling the tab on the ink cartridge out from the ink cartridge holder.
Center position
Ink cartridge disposal: Consult the
4.Remove the protective tape from the new ink cartridge.
5.Move the ink cartridge carriage to the center position.
6.Hold the ink cartridge holder and place the ink cartridge (bottom end first) into the holder and snap it into place.
7.Reinstall the imprinter into the scanner.
8.Turn on the scanner and the PC.
9.Launch the Ngenuity Operator Utility and confirm the imprinter is recognized.
Ink cartridge specifications
Subject | Specification |
|
|
Ink Cartridge Life | Approximately 4,000,000 characters (standard font) |
| Approximately 2,000,000 characters (bold font) |
|
|
Nozzles | 12 |
|
|
Unusable Documents | Plastic film or coated paper should not be used with the imprinter |
|
|
Storage Environment | Temperature: 32°F to 104°F (0°C to 40°C); Humidity: 10% to 80% RH |
|
|
Operating Environment | Temperature: 59°F to 86°F (15°C to 30°C); Humidity: 30% to 80% RH |
|
|