Kodak 9150DC, 9125DC Replacing the pre, Separation pad, Replacing the imaging, Guides, Lamps LEDs

Replacing the pre-	Change the pre-separation pad when the frequency of multi-fed
separation pad	documents increases.
	1.	Open the scanner cover.
	2.	Remove the pre-separation pad by lifting the pad up and out of
		position.

		NOTE: The pre-separation pad fits snuggly in place; therefore, a
		little force may be required to remove it.
	3.	Install the new pre-separation pad. Be sure it snaps into place.
	4.	Close the scanner cover.
Replacing the imaging	Replace the imaging guides when they become damaged or heavily
guides	scratched. See the section entitled, “Cleaning the optics” earlier in this
	chapter for detailed procedures about removing the imaging guides.
	1.	Open the scanner cover.
	2.	Gently pull the 2 fastening clips that secure the top imaging guide
		towards the front of the scanner to release and remove the imaging
		guide from the transport.
	3.	Install the new imaging guide into the scanner by holding the frame
		of the imaging guide so that the fastening clips are on the back side.
		Slide the guides under the transport tray towards the feeder table
		and ease the back side of the imaging guide into position.
	4.	Repeat Steps 2 and 3 to replace the bottom imaging guide.
	5.	Close the scanner cover.
Lamps (LEDs)	IMPORTANT: The LEDs on Ngenuity scanners should NOT be cleaned
		or wiped with any type of wipes and/or solvent.

The LED illumination system on Ngenuity Scanners should last the life of the scanner with normal use. If something happens that requires the replacement of the LEDs, contact Kodak Technical Support.

A-61662 October 2011 6-13