Barco R9002120 manual Location and Function of Controls

Location and Function of Controls

1

2

3

4

5

6

7

Back light key : when activated, all keys will be lit up and	8
visible in the dark.
ADJ. : adjust key, to enter or exit the adjustment mode.
Address key (recessed key), to enter the address of the
projector (between 0 and 9). Press the address key,
followed by pressing one digit button between 0 and 9.	9
STBY : stand by button :
- to initiate remote power up operation	10
- to stop projection without main power off.
Pause :to blank the image, press PAUSE. The image
	11
disappears but full power is retained for immediate restart-
ing.
Digit buttons : direct input selection.
Picture controls : use these buttons to obtain the desired
level (see also 'Controlling') for each picture function.	12

TEXT : when adjusting one of the image controls during a meeting, the displayed bar scale can be removed by pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key is only active in operational mode. When 'TEXT' is off, no warning message will be displayed.

ENTER : to start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode.

EXIT : to leave the adjustment mode or to scroll upwards when in the adjustment mode.

Control disk : to make menu selections when in the adjustment mode. Also allows to increment or decrement an adjustment in the adjustment mode.

control disk up = up arrow in the menus control disk down = down arrow in the menus

control disk to the right = arrow to the right on the menus control disk to the left = arrow to the left on the menus

RC operating indication : lights up when a button on the remote control is pressed. (This is a visual indicator to check the operation of the remote control)

5975977 BARCODATA 708 260597 2-3