Barco R9002120 Connecting a VS05 switcher to the projector, YYB-Y3S or R-YY3sB-Y input selection

Connections

(R-Y)Y(B-Y)3S or (R-Y)Y3s(B-Y) input selection

a. Press digit button 6 on the RCU or

b. With the local keypad :

(to gain access to the local keypad, see 'Local keypad' in chapter 'Location and function of controls'.)

-Press ADJUST key, the General access menu is displayed on the screen.

-Use the control disk to highlight 6.

-Press ENTER to select the highlighted source.

	GENERAL ACCESS
		SHARPNESS
		TINT
5	6	COLOR
3	4	BRIGHTNESS
1	2	CONTRAST

Enter ADJUST

Select with	,
	or
then <ENTER>.

<EXIT> to return

Connecting a computer, e.g. IBM PC (or compatible), Apple Macintosh to the RS232 input of the projector.

The projector has a RS232 port that allows it to communicate with a computer.

Applications: remote control and data communications.

a)remote control:

-easy adjustment of the projector via IBM PC (or compatible) or MAC connection.

-allow storage of multiple projector configurations and set ups.

-wide range of control possibilities.

-address range from 0 to 255.

b)data communications:

-sending data to the projector or copying the data from the projector to a hard memory device.

		COMM PORT	R	G(S)	B		S-VIDEO
RS232 IN	RS232 OUT	(800 peripherals) REM OTE				S VIDEO
			R-Y	Y(S)	B-Y

RS232 connection

Peripheral equipment

Connecting a RCVDS 05 switcher to the projector.

-Up to 10 inputs (20 inputs when video and S-video) with the RCVDS 05 switcher and up to 90 inputs when 10 RCVDS switchers are linked via the expansion modules.

-Serial communication with the projector.

-Remote control buttons on the RCVDS to control the projector (source selection and analog settings)

-The selected source number will be displayed on a 2 digit display and the selected input modules will be indicated with a LED on the rear.

For more information about the use of the RCVDS 05, consult the Owner's Manual, order number: R5975765.

Connecting a VS05 switcher to the projector.

The VS05 can switch up to 5 Composite Video sources, 3 S-Video Sources and 1 RGB analog or component Video source to the projector. In addition, the audio signal proper to the source, can be switched to an audio amplifier.

Order number : R9827890.

For more information about the use of the VS05, consult the Owner's Manual, order number: R5975245.

Connecting an IR Remote Receiver to the projector

This infra-red receiver unit makes it possible to control the projector from another room. There is a communication line cable between the IR receiver and the projector or the RCVDS. The infrared control information from the Remote Control Unit is sent to the IR Remote Receiver. The IR Remote Receiver 800 displays the selected source on a 7-segment display.

Order number : R9827515.

3 - 6 5975977 BARCODATA 708 260597