APC AP9608, AP9208 manual Customize Settings, Press any key to bring up the Main menu

Note the top line, which displays the model number of the UPS that is currently connected . Site ID and Location are user configuration items. The display shows the factory defaults.

Press any key to bring up the Main menu:

----------------------		MAIN	MENU ------------------------
Date: Dec-16 '97			Time: 08:39:36
1-	UPS	Status
2-	UPS	Control

3- UPS Characteristics

4- Data/Event Logging

5- Call-UPS Settings

6- Paging Setup

7- Measure-UPS Info ?- Help

<ENTER> Display Menu

<ESC> End Session

>

Customize Settings

From the Main menu, you can go to the various menus by pressing the number associated with each of them. Press 5, then ENTER to bring up the Call-UPSSettings menu. Set the date, time, password, location, and baud rate from this menu. The baud rate should be set at 9600. The other menu items can be left alone for now. Note that any changes you make are displayed when you return to the menu.

Then press ESC to return to the Main menu. Type 6 and press ENTER for the Paging Setup menu, where you can change the Site ID number from its default setting. If you will be using the paging capability of Call- UPS II, use this menu to enable and set up paging.

If you plan to use Call-UPSII for logging, go to the Main menu, type 4 and press ENTER for the Data/Event Logging menu. Proceed from there to set up logging.

To change any of the changeable setting of the UPS and Call-UPSII, use the other menus listed in the Main menu. For a full description of the en- tire menu scheme, see Section 4.

8