APC AP9208, AP9608 manual Call-UPS Settings, Call-Ups

4.6 Call-UPS Settings

To see or change Call-UPSII settings, go to the main menu and type 5, then press ENTER. You will see the following display.

---------------------	CALL-UPS	SETUP ---------------------
Model	Number: AP9608	HW Rev: A2
Serial	Number: WA718570411	F/W Rev: K
Manuf. Date: 6/27/97

---------------------------------------------------------

1-	Set Date: Sep-28 ’97	7-	Ansi Color:	Off
2-	Set Time: 10:38:06	8-	Baud Rate:	9600
3- Set	Password: ********	9-	Answer Ring:	0
4-	Dial Back: OFF	10-Answer Lockout: 0 min
5-Dial Back Str: DT5551212
6-	Location: Physical Location of This UPS

---------------------------------------------------------

11- UPS Present: ON

12- Reset Call-UPS to Default Settings ?- Help

<ENTER> Display menu

<ESC> Return to Previous Menu

>

The top section of the Call-UPSSetup menu displays the following Call-UPSII device information which will be needed in case technical support is required:

•	Model Number — the model number of Call-	UPS II
•	H/W Rev — the revision of the Call- UPS II hardware
•	Serial Number — the serial number of this Call- UPS II unit
•	F/W Rev — the revision number of the Call-	UPS II firmware
•	Manuf. Date — the date this Call- UPS II was manufactured

The remaining two sections of the Call-UPSSetup menu list changeable settings of Call-UPSII. For a description of these settings, see the table that follows.

29