APC AP9608, AP9208 manual UPS Control, Command Description

Page 24

4.3 UPS Control

For remote control of the connected UPS, go to the Main menu and type 2 and press ENTER. Call-UPSII displays the Control menu.

--------------------- CONTROL MENU ----------------------

1- Turn UPS ON

2- Turn UPS OFF

3- UPS Self Test

4- Simulate Power Failure

5- Graceful Reboot

6- Graceful Turn OFF

7- Start Runtime Cal (Stop Runtime Cal)

8- Put UPS in Bypass (Return from Bypass) ?- Help

<ENTER> Display menu

<ESC> Return to Previous menu

>

Select from the menu items to perform the following:

 

UPS CONTROL

 

 

Command

Description

 

 

Turn UPS ON

Restores power to the load.

 

 

 

Cuts off power to the load immediately. This does not

Turn UPS OFF

allow for graceful shutdown for operating systems that

 

require it.

 

 

UPS Self Test

Starts a UPS self test and disp lays the results.

 

 

Simulate Power

Puts the UPS on battery for a moment as if there were a

Failure

power failure.

 

 

 

Causes the UPS to cycle power to the attached computer

Graceful

to reboot it. Call-UPS II signals that the UPS is on

battery and that the battery is nearly exhausted. Graceful

Reboot

Reboot uses the value set for Low Battery Duration. See

 

 

UPS Characteristics table, Sec. 4.4.

 

 

20

Image 24
Contents Call-UPSII Thank You Contents Problem Resolution Introduction OverviewHardware Requirements Product Description Call-UPS II PanelManagement Port UPS Monitoring Port External VersionPower Port External Version UPS Cable External VersionWith Smart-UPS With Matrix-UPS Status Indicator Status LED IndicationInstallation and Setup InstallationHandling Receiving InspectionConfirm Operation External VersionConfigure Call-UPS Initial Logging OnCustomize Settings Press any key to bring up the Main menuConnect to Modem SmartSlot Configuration External Configuration UPS Status and Diagnostics OperationLogging On to Call-UPS With Smart-UPS and Matrix-UPS UPS Status Smart-UPS and Matrix-UPS Description Sleeping Inverter Shutdown With Symmetra Power Array UPS Status and Diagnostics Symmetra Power Array DescriptionUPS Status and Diagnostics Page RIM Page Command Description UPS ControlUPS Control UPS Control UPS Characteristics Call-UPS II will not allow changes to UPS characteristics Sensitivity of the UPS to power line fluctuation. Set this With Symmetra Power Array UPS Characteristics Symmetra Power Array Setting Description Data/Event Logging MenuDefault Description DATA/EVENT LoggingCall-UPS Settings CALL-UPSCALL-UPS II Settings CALL-UPS II Settings Default Description Paging Setup Site IDspace charactertrouble codePaging Setup Paging Setup Setting Default Description Paging Setup Events Event DescriptionMeasure-UPS Info ProbeMEASURE-UPS Info Problem Resolution Troubleshooting ChartTroubleshooting Problem Possible Cause SolutionIf Problems Persist Specifications Management Port PinoutPin Function Product Specifications ElectricalPhysical EnvironmentalAppendix Multiple SmartSlot Installation Device Priority PositionTriple Chassis Symmetra Power Array Daisy ChainsSmart-UPS and Matrix-UPS Page Page Page Limited Warranty Toll free technical support