APC AP9208, AP9608 manual

The System Status line at the bottom of the UPS Status and Diagnostics screen can display the following Symmetra status conditions:

•Runtime Calibration

•Waiting to Power Load

•Smart Boost

•Smart Trim

•On-Line

•On-Battery

•Low Battery

•Replace Battery

•In Bypass

•Sleeping – Delayed Wakeup

•Sleeping – Inverter Shutdown

•Forcing Graceful Shutdown

•Sleeping – Low Battery Shutdown

•Overload – Unable

•Bad Power Module

•Intelligence Module is in- stalled and failed

•Redundant Intelligence Module is installed and failed

•Bad Battery Module

•Load is above kVA alarm threshold

•Redundancy has been lost

•Redundancy is below alarm threshold

•Bypass is not in range (either freq or voltage)

•Bypass contactor stuck in bypass position

•Bypass Contactor stuck in on-line position

•UPS in bypass due to internal fault

•UPS in bypass due to over- load

•System is in Maintenance Bypass

•Input circuit breaker tripped open

•System level fan failed

•The Redundant Intelligence Module is in control

•IIC inter-module communica- tions failed

•Turn on requested, override required

•UPS will turn on automati- cally when conditions are met

•Runtime is below alarm threshold

•# of batteries increased

•# of batteries decreased

•# of power modules increased

•# of power modules decreased

•Intelligence Module inserted

•Intelligence Module removed

•Redundant Intelligence Mod- ule inserted

•Redundant Intelligence Mod- ule removed

•# of External battery Cabinets increased

•# of External Battery Cabinets decreased

17