APC AP9608, AP9208 manual Product Description, Call-UPS II Panel, Management Port

Page 6

2 Product Description

2.1 The Call-UPS II Panel

The SmartSlot Call-UPS II panel contains the management port and the status indicator. See the figure below.

Management Port

Status

Smart Slot

AP9608 Call-UPS Remote Mgt Device

The external Call-UPSII rear panel contains the management port, status indicator, UPS monitoring port, and optional power jack. See the figure below.

2.2 Management Port

The Call-UPSII management port is used for configuring Call-UPSII and for remote management and paging by modem. For specifications, see Sec. 6.1.

2.3 UPS Monitoring Port [External Version]

The UPS monitoring connector duplicates the signals from the UPS so that the normal computer-to-UPSconnection is maintained. This port is for use with APC software and interface kits only.

2

Image 6

Contents Call-UPSII Thank You Contents Problem Resolution Introduction OverviewHardware Requirements Management Port Product DescriptionCall-UPS II Panel UPS Monitoring Port External VersionPower Port External Version UPS Cable External VersionWith Smart-UPS With Matrix-UPS Status Indicator Status LED IndicationHandling Installation and SetupInstallation Receiving InspectionConfirm Operation External VersionConfigure Call-UPS Initial Logging OnCustomize Settings Press any key to bring up the Main menuConnect to Modem SmartSlot Configuration External Configuration UPS Status and Diagnostics OperationLogging On to Call-UPS With Smart-UPS and Matrix-UPS UPS Status Smart-UPS and Matrix-UPS Description Sleeping Inverter Shutdown With Symmetra Power Array UPS Status and Diagnostics Symmetra Power Array DescriptionUPS Status and Diagnostics Page RIM Page Command Description UPS ControlUPS Control UPS Control UPS Characteristics Call-UPS II will not allow changes to UPS characteristics Sensitivity of the UPS to power line fluctuation. Set this With Symmetra Power Array UPS Characteristics Symmetra Power Array Setting Description Data/Event Logging MenuDefault Description DATA/EVENT LoggingCall-UPS Settings CALL-UPSCALL-UPS II Settings CALL-UPS II Settings Default Description Paging Setup Site IDspace charactertrouble codePaging Setup Paging Setup Setting Default Description Paging Setup Events Event DescriptionMeasure-UPS Info ProbeMEASURE-UPS Info Troubleshooting Problem ResolutionTroubleshooting Chart Problem Possible Cause SolutionIf Problems Persist Specifications Management Port PinoutPin Function Physical Product SpecificationsElectrical EnvironmentalAppendix Multiple SmartSlot Installation Device Priority PositionTriple Chassis Symmetra Power Array Daisy ChainsSmart-UPS and Matrix-UPS Page Page Page Limited Warranty Toll free technical support