APC AP9208, AP9608 manual UPS Status Smart-UPS and Matrix-UPS Description

UPS STATUS (Smart-UPS and Matrix-UPS)

Item	Description
Utility Line	Utility line input, in volts AC RMS.
UPS Output	UPS output to the load, in volts AC RMS.
UPS Load	Connected load as a percentage of the rated capacity of the UPS.
Run Time	Estimate of the total run time currently available from the
	UPS, based on present load and battery, in minutes.
Load Power	Amount of power being drawn by the load, in volt-amps (if
	supported by the UPS).
Load Current	Amount of current being drawn by the load, in amps (if
	supported by the UPS).
UPS Temp	Current temperature inside the UPS, in degrees Celsius.
Freq	Output frequency of the UPS, in hertz.
	Reason for the last UPS transfer to battery. Possible results
Last Xfer	are: Test, Low Voltage, Hi Voltage, Rate of Change, and
	Notch/Spike.
Voltage	Total voltage of the UPS batteries, in volts DC.
Capacity	Battery charge as a percentage of capacity.
Smart Cells	Number o f Smart Cell battery packs connected to the UPS
	(only with Matrix-UPS).
Bad Cells	Number of Smart Cells connected to the UPS that have gone
	bad (only with Matrix-UPS).
Batt Date	Date of the last battery change.
	Results o f the last UPS self-test. Possible results are: OK,
Self Test	None (not available), Unable to Test (invalid results due to
	overload), and Battery Failed (due to insufficient capacity).

13