APC AP9208, AP9608 manual CALL-UPS II Settings Default Description

CALL-UPS II SETTINGS (Continued)

Setting	Default	Description
		Number of rings before the Call-UPS II modem
		answers a call. After each communication session, the
		modem SO register is set to this value. If the value is
Answer		0 (the default), Call-UPS II will send “ATSO=0,” and
	0	the modem will not answer calls. Set this value to 0
Ring
		to use Call-UPS II for paging only. With Answer
		Ring set to 0, Call-UPS II will not answer a stray call
		and will always be available for paging. Values from
		0 to 15 are accepted.
		Answer Lockout time interval, for use of multiple
		devices (like modems) on the same telephone line as
		Call-UPS II. When set to a non-zero value, the
		modem is prevented from accepting incoming calls
		during the defined interval after a communication
		session. To use Answer Lockout, make sure the
Answer	0 min	modem attached to Call-UPS II is th e first device in
Lockout		the telephone line chain (see figure at end of Sec.
		3.5). When this feature is enabled, the next device
		down the chain will get as many rings as it needs to
		answer a call. Make sure that all other automatic
		answering devices on the line with Call-UPS II are set
		to answer in a greater number of rings than Call-UPS
		II. Values from 0 to 99 minutes are accepted.
		States whether Call-UPS II is connected to a UPS.
UPS	ON	Change the default setting (ON) if Call-UPS II is
Present		connected only to Measure-UPS. This shortens the
		menu structure and the polling sequence.
Reset …		Resets Call-UPS II to factory defaults.

31