APC AP9208 With Symmetra Power Array, UPS Status and Diagnostics Symmetra Power Array Description

With Symmetra Power Array

Type 1, then ENTER at the Main menu to display the Status and Diagnos- tics screen of the connected Symmetra Power Array.

-----------------------------		SYMMETRA STATUS			-------------------------------
IM Status: On & Ok					Last Xfer: None
RIM Status: Off & Failed				Last Self test: OK
------------------------------		INPUT/OUTPUT ---------------------------------
Input:	246.0 V at 60.04 Hz			Load Assuming No Redundancy: 000 %
Output:	000.0 V at 60.04 Hz			Allowing for n+1 Redundancy: 000 %
Load Current:	00.0 A				Capacity:	16.0 kVA
					Alarm if Over: 06.0 kVA
-----------------------------		POWER MODULES ---------------------------------
Installed:	05				Fault Tolerance:	n+0
Bad:	00				Alarm if Under:	n+2
-------------------------------		BATTERIES -----------------------------------
Installed:	004	Voltage:	137.1 VDC		Runtime: 0244 min.
Bad:	000	Capacity:	98.0 %		Alarm if Under: 015 min.

System Status:On-Line

1- Main Frame Information

2- External Battery Frame Information for frame(s): 1, 2, 3, 6, 7 <ENTER>=Refresh, <ESC>=Main menu>, ?=Help>

The following table describes the items on the UPS Status and Diagnos- tics screen when Call-UPSII is used with a Symmetra Power Array. The table continues on the next page.

UPS STATUS AND DIAGNOSTICS (Symmetra Power Array)

Item	Description
IM Status	Status of the Intelligence Module.
RIM Status	Status of the Redundant Intelligence Module.
	Reason for the last UPS transfer to battery. Possible
Last Xfer	results are: Test, Low Voltage, HiVoltage, Rate of
	Change, and Notch/Spike.
Last Self Test	Results of the last Self Test. Possible results are listed
	in earlier Self Test Table in this section.
Input	Utility line input, in volts AC RMS and in hertz.
Output	UPS output to the load, in volts AC RMS and in hertz.
Load Current	Amount of current being drawn by the load, in amps.

15