APC AP9208, AP9608 manual Symmetra Power Array, Daisy Chains, Smart-UPS and Matrix-UPS

Page 47

Symmetra Power Array

For installation of multiple SmartSlot devices in the Symmetra Power Array, refer to the numbering in the figure that follows. Note that the PowerNet SNMP Adapter is installed in slot #4, Call-UPSII in #3, no device in #2, and Measure-UPS in #1.

If you are using an external SmartSlot housing (Expansion Chassis or Triple Chassis) in conjunction with a Symmetra Power Array, install the devices with higher priority in the external slot(s). Refer to the earlier Triple Chassis section, if applicable.

4

3

2

1

Battery Communications

Comm. 1 Comm. 2

Computer

Interface

Display

Comm.

 

Reset

PowerNet™ SNMP Adapter™

 

 

AP9605

 

 

Smart Slot

RX/TX

Status

 

Link -

 

 

Status

Management Port

MgtRemote viceDe

AP9608 UPS-Call

SlotSmart

GND 1 2 3 412

Sensor ZonesProbes

AP9612 UPS™-Measure

SlotSmart

Daisy Chains

If you have increased your SmartSlot capacity by daisy-chaining Expansion Chassis or Triple Chassis, install the PowerNet SNMP Adapter and Call-UPSII in the highest-numbered and second-highest- numbered slots, respectively, of the chassis installed farthest from the UPS.

Smart-UPS and Matrix-UPS

If your APC UPS has only one SmartSlot, install the low-priority devices in the UPS SmartSlot and use an external SmartSlot housing (Expansion Chassis or Triple Chassis) for the device(s) with higher priority. Refer to the earlier Triple Chassis section, if applicable.

43

Image 47
Contents Call-UPSII Thank You Contents Problem Resolution Hardware Requirements IntroductionOverview UPS Monitoring Port External Version Product DescriptionCall-UPS II Panel Management PortWith Smart-UPS With Matrix-UPS Power Port External VersionUPS Cable External Version Status LED Indication Status IndicatorReceiving Inspection Installation and SetupInstallation HandlingExternal Version Confirm OperationInitial Logging On Configure Call-UPSPress any key to bring up the Main menu Customize SettingsConnect to Modem SmartSlot Configuration External Configuration Logging On to Call-UPS UPS Status and DiagnosticsOperation With Smart-UPS and Matrix-UPS UPS Status Smart-UPS and Matrix-UPS Description Sleeping Inverter Shutdown UPS Status and Diagnostics Symmetra Power Array Description With Symmetra Power ArrayUPS Status and Diagnostics Page RIM Page UPS Control Command DescriptionUPS Control UPS Control UPS Characteristics Call-UPS II will not allow changes to UPS characteristics Sensitivity of the UPS to power line fluctuation. Set this With Symmetra Power Array UPS Characteristics Symmetra Power Array Setting Description Menu Data/Event LoggingDATA/EVENT Logging Default DescriptionCALL-UPS Call-UPS SettingsCALL-UPS II Settings CALL-UPS II Settings Default Description Site IDspace charactertrouble code Paging SetupPaging Setup Paging Setup Setting Default Description Event Description Paging Setup EventsProbe Measure-UPS InfoMEASURE-UPS Info Problem Possible Cause Solution Problem ResolutionTroubleshooting Chart TroubleshootingIf Problems Persist Pin Function SpecificationsManagement Port Pinout Environmental Product SpecificationsElectrical PhysicalTriple Chassis Appendix Multiple SmartSlot InstallationDevice Priority Position Smart-UPS and Matrix-UPS Symmetra Power ArrayDaisy Chains Page Page Page Limited Warranty Toll free technical support