Vixel Model 335 Installation & Configuration Guide | CHAPTER 3 Management |
|
|
Note: To configure switch settings, you must be logged into the Web Manager.
Configuring the Switch
A quick list of frequent configuration tasks and their locations is shown here. More detailed information on each configuration task follows the table. Once you reach the location, you may need to click Change Settings and/or other links or buttons before configuration parameters are available for changing.
Configuration Task | Location in Web Manager |
|
|
Change the switch speed | System > Change Settings |
(See “Switch Speed” on page 16.) |
|
|
|
Change device identification, contact, and | System > Change Settings |
location |
|
(See “Switch Identification” on page 16.) |
|
|
|
Upgrade firmware | System > Firmware |
(See “Firmware Settings” on page 18.) | (click Load New Firmware Image) |
|
|
Change the network settings (IP Address, | System > Change Settings |
Gateway, and Netmask) |
|
(See “Network Settings” on page 15.) |
|
|
|
Change the time settings | System > Time > Change Time Settings |
(See “Time Settings” on page 17.) |
|
|
|
Configure zoning | Zoning |
(See “Zone Settings” on page 31.) |
|
|
|
View & download event log | System > Event Log |
(See “Event Log Messages” on page 19.) |
|
|
|
Reset switch | Home (click Reset Switch) |
(See “Resetting the Switch” on page 13.) |
|
|
|
View & update policies | Policy |
(See “Policy Settings” on page 29.) |
|
|
|
General switch status is shown on the Home page (click Home). You can click the options at the top of the page to view additional information and configure the switch. These options are discussed in more detail on the following pages.
Resetting the Switch
Changes to certain switch settings require you to reset the switch for those changes to occur. You must be logged into the Web Manager to reset the switch.
To reset the switch, click Reset Switch on the Home page.
13