Vixel Model 335 Installation & Configuration GuideCHAPTER 3 Management
6. Type fw, then type 1.
The active and alternate firmware versions are displayed.
7.If the “alternate version” is anything other than the firmware you just downloaded, verify that the file is good and repeat the download.
8.If you want to activate the alternate version (the newly downloaded firmware):
a.Type 2 to select the alternate version for execution on the next boot cycle.
b.Type 1 to verify that the following message is displayed under the firmware versions: “Note: ALTERNATE selected for execution on next boot cycle.” (If this message is not displayed, repeat steps a and b to toggle back.)
c.Type 5 to reboot.
The management agent disconnects, reboots, and activates the downloaded firmware. The “Disconnecting and Rebooting” message appears.
The firmware is downloaded.
Configuring the Trap Destination Table
Simple Network Management Protocol (SNMP) uses traps to transmit information to other IP Addressable devices on the network.
To view the current Trap Destination settings and a complete list of commands, type: ct at the prompt. The Trap Destination Table Menu appears:
TRAP DESTINATION TABLE MENU |
|
IP ADDRESS | PORT SEVERITY COMMUNITY STATE |
Event traps: <none> |
|
FcMgmt traps: <none> |
|
1.Create new TRAP destination
2.Delete TRAP destination
3.Exit menu
To create a trap destination:
1.Type 1 to create the new TRAP destination.
2.At the resulting IP address prompt, type the address of the workstation you would like the trap sent to.
3.At the resulting UDP Port prompt, type the number of the listening port (usually “162”).
The Edit Trap Destination Menu appears.
EDIT TRAP DESTINATION MENU |
| ||
|
| ACTIVE VALUE | NEW VALUE |
| IP Address | 172.16.52.2 | 172.16.52.2 |
| Port | 162 | 162 |
1. | Community | 'public' | 'public' |
2. | Severity | Warning | Warning |
3. | State | Inactive | Inactive |
4. | Mode | Event | Event |
5. | Save changes and exit menu |
| |
6. | Discard changes and exit menu |
| |
|
|
|
|
41