Vixel 335 manual Appendix C Event Messages, Event Meaning Action Severity Message

APPENDIX C Event Messages

The event messages are listed by reference number. Also included are the event descriptions, recommended actions, reference numbers, and the message’s applicable severity level, which are each defined below:

•Emergency—immediate action required; system failing

•Alert—unrecoverable condition reported; major event in progress

•Critical—event failed with possible loss of integrity

•Error—condition failed; action required

•Warning—failed event occurred; no action required

•Notice—configuration error or abnormal event occurred; no action required

•Info—event occurred; no action required

•Debug—internal message for development (excluded in this list)

•Mark—message marker (excluded in this list)

These severity levels can be used to designate which events trigger trap messages. For Vixel Switches, you can also designate the minimum severity level of events to be logged in the Event Log and at which to illuminate the switch’s Fault LED.

Ref	Event	Meaning	Action	Severity
	Message
1	Agent up	The switch’s management agent	---	Info
		was up. (This message begins
		the event log at each session.)
3	Switch added	The switch was added.	---	Info
5	Switch reset	The switch was reset.	---	Info
10	Switch loopback	ASIC failed its power on self	Contact an authorized	Alert
	failure	test (internal test).	service representative.
20	Smart insertion	The Smart Insertion policy is	---	Notice
	mode on	enabled.
21	Smart insertion	The Smart Insertion policy is	---	Notice
	mode off	disabled.
22	Switch in switching	The switch is running in switch-	---	Notice
	mode	ing mode.
23	Switch in normal	The switch is running in normal	---	Notice
	mode (switching off)	mode (switching is disabled).
100	Fan okay	The state of a switch fan	---	Info
		changed to “okay.”
101	Fan fault	The state of a switch fan	Replace the fan.	Alert
		changed to “fault.”
110	Temperature okay	The switch temperature	---	Info
		changed to “okay.”
111	Temperature warm	The switch temperature	---	Warning
		changed to “warm.”
112	Temperature hot	The switch temperature	Power off the switch and	Alert
		changed to “hot.” A fan may	contact an authorized
		have failed or the temperature	service representative.
		of the location may be exceed-
		ing the switch’s environmental
		requirements.
120	Power okay	The state of the switch power	---	Info
		supply changed to “okay.”
121	Power fault	The state of the switch power	---	Alert
		supply changed to “fault.”

63