Vixel 335 manual Cls

Vixel Model 335 Installation & Configuration Guide		CHAPTER 3 Management
	RRDY	The receiving node on this port has sent an R_RDY signal,
		indicating that it is ready for a frame to be transmitted over the
		link.
	CLS	The port is attempting to begin the process of closing the current
		loop circuit.
	OPN	The port is attempting to open communications with another
		port on the loop. Note: As is the case with some ordered sets, an
		OPN may not go all the way around the loop, instead stopping
		at its destination.
	LIP F8	A non-switching port has detected a loop failure on its receive
		input, is notifying other ports, and is determining whether the
		loop is still operational.
		Some events that could cause the port to detect loop failure
		follow:
		• A device in the loop has failed.
		• A device in the loop has been powered off.
		• The physical connection between the transmitter and receiver
		is broken.
		• Activating the port bypass circuit does not typically result in a
		loop failure.
	LIP F7	A loop port is in the non-participating mode and is attempting
		to win arbitration and begin initialization, possibly because the
		port was reset or is powering up. Sometimes the port is sending
		this sequence to another, hot-cascaded switch like a new initiator
		being inserted in the loop.
	LIP	A Loop Initialization Primitive (LIP) sequence has been detected
		and action has been taken.
	Unknown	The switch can not determine what is being transmitted.
	InvTxWd	An invalid transmit word has been detected.
	CRC Err	A Frame CRC error has been detected.
	Pt-to-Pt	A point-to-point connection has been detected.

22