Vixel manual Vixel Model 335 Installation & Configuration Guide

Vixel Model 335 Installation & Configuration Guide				APPENDIX C Event Messages
	Ref	Event	Meaning		Action	Severity
		Message
	203	Port switch connect	A number of stalls have		---	Info
		overflow	occurred in a specific amount
			of time.
	204	Port switch stall	An instance occurred where		---	Info
			two devices could not discon-
			nect communications with one
			another.
	205	Port switch bad	A device is trying to send an		---	Info
		open	OPN but it cannot be delivered.
	206	Port clock delta freq	The switch clock or a device		---	Info
		error	clock are not synchronized. If
			the switch clock has failed, the
			error should display on multi-
			ple ports. If only one port is
			logging this error, it is most
			likely a problem with that
			device.
	207	Port clock delta freq	The switch clock and a device		---	Info
		ok	are synchronized.
	208	Bad zone detected	Refers to the zone health.		---	Info
	209	Cascade user mode	A user setting for cascades has		---	Info
		overridden	been overridden by the firm-
			ware.
	210	Console password	The command line interface		---	Notice
		changed	password was changed. Note:
			The password cannot be
			changed without supplying the
			current password, even if
			logged on.
	241	Port bypassed	A port was bypassed manually,		---	Info
		(external loopback)	through either the command
			line interface or a management
			entity.
	242	Port bypassed	A port was bypassed manually,		---	Info
		(diagnostic TX)	through either the command
			line interface or a management
			entity.
	243	Port bypassed (Loss	Although a transceiver is		---	Info
		of RX signal)	present, the port is bypassed
			because there is no signal com-
			ing into the port.
	244	Port bypassed (Loss	Although a transceiver is		---	Info
		of Sync)	present, the port is bypassed
			because the port lost sync with
			the fibre channel signal (no
			command characters were
			received).
	250	Port transmitter	A port transmitter was turned		---	Notice
		enabled	on, through either the com-
			mand line interface or a man-
			agement entity.
	251	Port transmitter	A port transmitter was turned		---	Notice
		disabled	off, through either the com-
			mand line interface or a man-
			agement entity.
	260	Key feature enabled	A purchased license key for an		---	Info
			optional feature was entered,
			through either the command
			line interface or a management
			entity.
	261	Key feature disabled	An optional feature was dis-		---	Notice
			abled, through either the com-
			mand line interface or a
			management entity.
	270	Daytime server up	The daytime server is running.		---	Info
	271	Daytime server	The daytime server is not run-		---	Notice
		down	ning.

65