Bay Technical Associates DS2-RPC DS4-RPC, DS73, DS2-RPC, DS4-RPC Controlling Receptacles

DS-RPC OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

__________________________________________________________________________________________

	If the status menu fails to appear, ensure the
	correct cables and adapters are being used
	and they are connected properly. Also,
	verify the serial communication parameters
	are correctly configured.
Controlling Receptacles	To set or change the status of receptacles,
	enter one of the following commands: ON
	n, OFF n, REBOOT n, where “n” is the
	outlet number you want to command.
	Entering an outlet number of “0” sends the
	command to all outlets.
Example:	To turn “On” Outlet 3, type ON 3 from the
	DS-RPC prompt (RPC >). The RPC
	responds:
	Turn On Outlet 3 (Y/N)?
	Responding “Y” for yes turns “On” Outlet 3.
	Observe the status of Outlet 3 has changed
	to “On” in the status menu:

DS-RPC Power Control

(c)1997 by BayTech Rev. F0.04

Circuit Breaker : On

1) . . . OUTLET 1	: Off
2) . . . OUTLET 2	: Off
3) . . . OUTLET 3	: On
4) . . . OUTLET 4	: Off
RPC >

Likewise, typing ON 0 at the RPC > prompt and responding “Y” for yes, turns “On” all outlets. Typing OFF n at the RPC > prompt turns off corresponding outlet(s).

63