Paging
If your system has paging equipment, you can use it to make announcements to one or more areas or “zones.”
Use the Paging Zones table in the Reference section to record the location of the paging zones.
To make a page
The Source and Destination areas of your screen must be clear.
1.Press Pager.
If you have only one paging zone, you will be immediately connected to the pager.
2.Make your announcement.
If you have more than one paging zone
•After pressing Pager, dial the
Listen for a long beep. Once you are connected to the paging circuit, one of these messages appears on your screen:
‘Page Zone Busy’ — someone else is accessing the paging equipment. Try again later, or press [Override] (if this is allowed in either your or the paging unit’s Class of Service) to interrupt the page in progress.
‘Page Zone Unassigned’ — you do not have access to that paging zone.
‘Connected to Pager’ — you are connected and can make your announcement.
To end a page
•Press Cancel or Release.
You are disconnected from the paging equipment.
38 ♦ Advanced Features