ResMed 608140/20611 manual Disassembling for Cleaning, Cleaning the Mask in the Home, Weekly

Page 8

Disassembling for Cleaning

See section C on the illustrations sheet.

1Detach the mask from the air tubing.

2Disconnect the headgear clips to release them from the mask frame. It is not necessary to remove the headgear clips from the headgear.

3Remove the port caps from the mask frame.

4Detach the cushion assembly from the mask frame by depressing the cushion clip at the base of the mask frame and gently pulling it off. This releases the cushion and cushion clip.

Then, separate the cushion from the cushion clip.

5To detach the elbow from the frame, lift (C-1) and push (C-2) the right wing of the elbow retainer over the right L-shaped ridge on the mask frame.

6Rotate the elbow retainer to the position shown in C-3. The elbow retainer is now in the correct position for removal.

7To remove the elbow retainer, hold one wing of the elbow retainer down, and firmly pull the other wing out (C-4a) and then up (C-4b) over the top of the elbow. Remove the elbow retainer and elbow from the mask frame.

8To remove the forehead support from the mask, press the tab (C-5a) and move it upwards until it is possible to slide it off the mask frame (C-5b).

9Pull firmly at the base of the forehead support pad plugs to release the pads from the forehead support (C-6).

Cleaning the Mask in the Home

Notes:

•Wash your hands before cleaning the mask.

•It is important to always handwash the headgear.

•The headgear may be washed without being disassembled from the headgear clips.

Daily/After each use

Handwash the mask components in warm (approx. 86°F/30°C) water using mild soap or detergent. Rinse the components well and allow them to air dry out of direct sunlight.

The mask components have been tested using DoveTM Unscented beauty bar.

Weekly

Handwash the headgear in warm (approx. 86°F/30°C) water using mild soap or detergent. Rinse well and allow it to air dry out of direct sunlight.

4

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Ultra Mirage Ultra Mirage Non-vented Full Face Mask BC-6 Ultra MirageTM Intended Use Fitting the Mask About the MaskParts of the Mask Removing the Mask Gently tighten the lower headgear straps B-4Disassembling for Cleaning Cleaning the Mask in the HomeDaily/After each use WeeklyCleaning the Mask between Patients Detergent Solution any oneReassembling the Mask DisposalTechnical Specifications Symbols Ordering InformationLimited Warranty Page Usage prévu Avertissements ET PrécautionsMise en place du masque Propos du masqueComposants du masque Remarques Retrait du masque Démontage pour le nettoyageNettoyage du masque à domicile Nettoyage du masque entre les patientsQuotidien/Après chaque utilisation HebdomadaireRemontage du masque Par ex., AlconoxEspace mort CaractéristiquesFuites au masque non intentionnelles Symboles NormesPression de fonctionnement RésistanceInformations de commande MasqueGarantie limitée Uso indicado PrecauciónColocación de la mascarilla Acerca de la mascarillaPiezas de la mascarilla Notas Extracción de la mascarilla Desmontaje para la limpiezaLimpieza de la mascarilla en el domicilio Limpieza de la mascarilla entre pacientesDiariamente o después de cada uso SemanalmenteMontaje de la mascarilla Detergente Solución cualquieraEspacio muerto Especificaciones técnicasFugas accidentales de la mascarilla Dimensiones SímbolosNormas Presión de funcionamientoInformación para solicitudes de envío SistemaGarantía limitada Função Advertências E PrecauçõesSobre a Máscara Peças da MáscaraColocação da Máscara Remoção da Máscara Desmontagem para LimpezaDiariamente / Após cada utilização Limpeza da Máscara no LarLimpeza da Máscara entre Pacientes Montagem da Máscara Detergente Solução qualquer uma delasEspecificações Técnicas Fuga Acidental da MáscaraEspaço Morto Pressão de FuncionamentoDimensões Informações sobre PedidosResistência Garantia Limitada
Top Page Image Contents