Panasonic KX-FL421 manual FCC and Other Information, Compliance with TIA-1083 standard

Page 67

11. General Information

11.3 FCC and Other Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

CAUTION:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult your retailer/dealer or an experienced radio/TV technician for help.

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the rear of this equipment is a label that contains, among other information, a product identifier in the format US:ACJ-----

-----.

If requested, this number must be provided to the telephone company.

•Registration No .....(found on the rear of the unit)

•Ringer Equivalence No. (REN)

...............................(found on the rear of the unit)

A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant.

The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five

(5.0).To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. For products

approved after July 23, 2001, the REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3).

If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.

If trouble is experienced with this equipment, for repair or warranty information, please contact a Factory Service Center or other Authorized Servicer. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.

Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.

If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer.

This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 68.316.

WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS:

1)Remain on the line and briefly explain to the dispatcher the reason for the call.

2)Perform such activities in the off-peak hours, such as early morning or late evenings.

Compliance with TIA-1083 standard:

Telephone handsets identified with this logo have reduced noise and interference when used with T-Coil equipped hearing aids and cochlear implants.

Compatible with

Hearing Aid T-Coil

T

TIA-1083

67

Page 66 Page 68
Image 67
Page 66 Page 68
Contents Compact Laser Fax Operating InstructionsEnvironment Things you should keep a recordThank you for purchasing a Panasonic fax machine For your future referencePower and ground connection For your safetyInstallation Operating safeguards CIS’s LED light properties Installation and relocationLaser radiation LED lightFor best performance Important safety instructionsIt is unlawful to make copies of certain documents Illegal copiesCopy Index To place an order by telephone Telephone 800 Supplied accessoriesAccessory information To place an order by fax Fax 800Description of buttons 9 j k l OverviewToner cartridge and drum unit Toner save feature Paper stacker Paper trayHandset cord Document stackerCorrectIncorrect Recording paperInsert the tabs on the A4 paper guides 1 into the slots To use A4-size paperConnections Using surge protectorsSet Dialing modeHelp function Set MenuDate and time Adjusting volumeTo correct a mistake If you have subscribed to a Caller ID serviceYour logo Handset Mute Flash StopTo change uppercase or lowercase letters To select characters using a or BKeypad Characters To enter your logo Example BillFlash Stop Your fax numberYour FAX no Press SET To search for a name by initial Example Lisa Making a phone call using the phonebookEditing a stored item StopErasing a stored item One-touch dial featureErasing a stored item Caller ID serviceHow Caller ID is displayed Monitor Stop Start Erasing caller informationErasing all caller information Erasing specific caller informationMenu Into the phonebookInto the one-touch dial Caller IDMonitor Sending a fax manuallyRedial/Pause Start Quick Scan Document requirements Programming items into the broadcast memory Broadcast transmissionSending the same document to pre- programmed parties To cancel broadcast transmissionAdding a new item into the broadcast memory Erasing a stored item from the broadcast memoryStart Stop Activating TEL modeReceiving a fax automatically Auto answer on Receiving a fax manually Auto answer OFFSetting up the unit and an answering machine Using the unit with an answering machinePress Junk Fax Prohibitor Activating the junk fax prohibitorStoring undesired callers Receiving a voice message and fax document in one callFax Programming the ring pattern assigned for fax Distinctive Ring serviceUsing two or more phone numbers on a single telephone line Activating the Distinctive Ring featureMaking a copy More copying featuresStart Copy Example Making 2 copies of a 4-page original document To collate multiple copiesSetMenu ProgrammingFeature/Code Selection Setting the quick setup Basic featuresOutside calls Advanced features Paper Changing the LCD display Normal default ContrastSound 700msec default Programmable Features Message Code Cause & Solution Error messages ReportsDisplay Cause & Solution Error messages DisplayPossible Transmission error occurred. Try againMessage Initial settings When a function does not workGeneral Fax receiving Fax sendingCopying If a power failure occurs Using an answering machineFuser unit 3 gets hot. Do not touch it Replacing the toner cartridge and the drum unitToner LOW Toner Empty Toner cartridge Model No. KX-FAT88 and drum unitInside of the drum unit to maintain the print quality Be sure to clean all the way to the edge of each grooveHelp Waste disposal method Recording paper jam Paper Jams Document jams Paper Jams Cleaning the inside Unit Cleaning Reference lists and reports Specifications 15 % image area Toner life% image area 10 % image areaCompliance with TIA-1083 standard FCC and Other InformationPanasonic Facsimile/Multi-Function Product Limited Warranty Limited Warranty United States and Puerto RicoCustomer Services Directory United States and Puerto Rico Customer Services directoryIndex Index PNQX3022ZA CM0810DT0 No Extra Cost
Related manuals
Manual 1 pages 28.66 Kb
Top Page Image Contents