Teledyne 4060 manual Operation

Series 4060

3.3 User Connections		28
3.3.1 Electrical Power Connections		28
3.3.2 Electronic Connections		28
3.3.2.1 Primary Input Power		29
3.3.2.2 Fuse Installation		30
3.3.2.3	50-Pin Equipment Interface Connector	30
3.3.2.4	Analog Output	30
3.3.2.5	Alarm Relays	32
3.3.2.6	Digital Remote Cal Inputs	34
3.3.2.7	Range ID Relays	35
3.3.2.8	Network I/O	35
3.3.2.9 Pin Out Table		35
3.3.2.10 RS-232 Port		36
3.3.3 Gas Connections		37
3.3.3.1 Effluent		40
3.3.3.2 Sample Bypass Vent		40
3.3.3.3 Fuel and Air Connections		40
3.3.3.4 Sample and Span Gas Connections		40
3.4 Placing the System in Operation		40
Operation ..................................................................................... 41
4.1 Equipment		41
4.2 Preliminary Power-Off Check List		42
4.3 Activating the Support Gases		42
4.3.1 Air		43
4.3.2 Carrier Gas		43
4.3.3 Span Gas		43
4.3.4 Fuel		43
4.4 Flame Ignition		43
4.4.1 Verification of the Flame Guard Circuit		44
4.4.2 Ignition and/or Flame Guard Circuit Failure		44

x Teledyne Analytical Instruments