Teledyne 4060 manual Main Menus

Series 4060 Operation

2.The MAIN MENU and SUB MENU screens have a flashing arrow on the left side indicating which item is being pointed to.

3.MODIFIABLE ITEM screens have a flashing value somewhere in the line.

4.6.4.1MAIN MENUS

The MAIN MENU consists of 15 functions you can use to customize and check the operation of the analyzer. They are listed here with brief descriptions:

SPAN: Set up and/or start a span calibration

ALT-SPAN: Set up and/or start an alternate span calibration.

MODEL: Displays Manufacturer, Model, and Software version of the instrument.

SELF-TEST:The instrument performs a self-diagnostic routine to check the integrity of the power supply, output boards, cell and amplifiers.

ALARMS: Used to set the alarm setpoints and determine whether each alarm will be active or defeated, HI or LO acting, and failsafe or not.

RANGE: Used to set up three analysis ranges that can be switched manually.

ANALOG-OUT ADJUST: Adjust the analog output with offset and scaling.

LINEARIZATION: Linearization option.

CHANGE STREAM: (optional feature) Controls a relay switch for using alternate gases. Has no effect during span mode (span gas relay setting used at that time).

AUTO-CAL:Used to define and/or start an automatic calibration sequence. AUTOCAL is an optional feature not included in the standard configurations of the 4060.

TIMING: Low level application specific timing parameters. Factory set. Do not change these.

Teledyne Analytical Instruments 49