Panasonic TY-ST65VX100 Attaching the pedestal to the display, Attaching the light-blocking panel

English

Attaching the pedestal to the display

For setting up the pedestal, refer to the operating instructions of plasma display.

1 Attach the plasma display to the pedestal.

Arrow marks are displayed on the back cover at the locations shown below.

Align the stand pins with these arrows, and install the plasma display.

2 Attach the stand poles.
(1) Insert the two stand poles		into the stand base			Rear	F
from the rear of the plasma display, and then
use the stand pole fixing screws			to secure the
stand poles .						B
• The stand poles	have a front and back.
(2) Use the four stand pole display fixing screws				to
secure the stand poles		and plasma display.			B	B

Attaching the light-blocking panel

1 Prepare the light-blocking panel.	1	Cloth sheet
(1) Place the light-blocking panel with the cloth	H	Notch
sheet facing upward.

(2)Fold over the portion of the panel with notches and holes in it along the crease. (See illustration.)

2

2 Attach and secure the light-blocking panel.

(1) Slightly bend the light-blocking panel to form	H
a U-shape and fit the ends into the gaps (right
and left) between the stand pins and the plasma
display. Align the notches in the light-blocking	D
panel with the stand pins.	Front
• The cloth sheet side should be facing the rear
panel of the plasma display.	H

F

(2) Align the four holes in the light-blocking panel	C
with the holes in the stand base, insert the (four)
fixing pins , and push down hard on the tops of
the fixing pins to lock them in place.

1	2
H

4